Working on a RAF Aircraft Hanger

We have been working on a RAF Aircraft hanger, removing two large areas of concrete to form doorways to accept new doors. We needed to break out two areas of concrete each measuring 3.0m x 3.0m and 400mm deep.

Tyrolit WSE Track Saw.

Step 1: Track Sawing

We cut form the perimeter of the 3.0m x 3.0m opening using the Tryolit WSE Track Saw.

Stitch drilling using the Husqvarna DM 340 Drill Rig and Motor

Step 2: Stitch Drilling

We then stitch drilled the corners with the Husqvarna DM 340 Drill Rig and Motor. This was to prevent overcutting at the end of the cuts.

Breaking out the concrete using the Demolition Robot Husqvarna DXR145.

Step 3: Breaking Out

We were then ready to break out the concrete using Demolition Robot Husqvarna DXR145.

Completed work, ready for new doors

Working on a RAF Aircraft Hanger